Outeio; Outfio - Agilent Technologies 4294A Programming Manual

OUTEIO

Syntax OUTEIO <numeric>
Description
If input/output port E (port C + port D) of the 24-bit I/O port has been set to an output port
(by the execution of the "COUT" command on page 283 and "DOUT" command on page
307), outputs data to port E. Data is outputted as 8-bit binary, assuming that C0 is LSB and
D3 is MSB. If port C or port D is set to an input port, executing this command causes an
error and the command is ignored. This command has the same function as the WRITEIO
16,4 command of Instrument BASIC. (No query)
Parameters
Description
Range
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Corresponding No front panel key is available to execute this function.
key

OUTFIO

Syntax
OUTFIO <numeric>
Description Outputs data to output port F (port A + port B) of the 24-bit I/O port. Data is outputted as
16-bit binary, assuming that A0 is LSB and B7 is MSB. This command has the same
function as the WRITEIO 16,5 command of Instrument BASIC. (No query)
Parameters
Description
Range
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Corresponding
No front panel key is available to execute this function.
key
Chapter 16
<numeric>
Output data
0 to 255
1
<numeric>
Output data
0 to 65535
1
GPIB Command Reference
OUTEIO
371