Service; Dispense Chute Cover Removal; Auger Motor Assembly Removal; Gate Assembly Removal - Follett U155B Installation, Operation & Service Manual

Service

Dispense chute cover removal

1. Remove top cover.
2. Push chute cover up vertically to slip off
holding tab.
3. After clearing tab, pull chute cover forward
to remove.

Auger motor assembly removal

1. Remove top cover.
2. Remove one thumbnut on rear of motor bracket.
3. Lift motor bracket and motor up, unplug electric
quick disconnects and remove.
Dispense mechanism assembly removal (Fig. 2)
1. Remove top cover.
2. Remove chute cover (see above).
3. Remove auger motor assembly (see above).
4. Remove quick release pins from the ice chutes
and gates, then unplug wires from solenoids.
5. Lift dispense mechanism up and off auger tube.
Auger and auger tube removal (Fig. 3)
1. Remove auger motor and dispense mechanism
assembly (see above).
2. Pull auger upward to clear auger tube.
3. Lift auger tube upward to clear dispenser top.
4. Slide tube and bearing plate through auger
tube gasket.
Dispense wheel removal
1. Remove drain pan assembly and bin access
cover.
2. Remove center thumbnut and threaded rod on
dispense wheel assembly and lift wheel out
front access opening.
Fig. 1 RH, 8-valve unit
Front View
top cover
drain pan
assembly
Dispense assembly, Top View
Fig. 2
(RH unit with bath shown)
gate
ice
chute
quick
release
pin
quick
release
pin
Fig. 3
auger motor
Side View
baffle
plate
auger
bearing
plate
wheel
motor
mounting
plate
13
valves
solenoid
dispenser
Front View
auger
stationery
agitator
auger
tube
rotating
dispense
agitator
wheel
wheel
motor
chute
cover
dispense
chute