Table of Contents
Advertisement
Quick Links
U300K Series Integral Cold Carbonation
Order parts online
www.follettice.com
Following installation, please forward this manual
Ice and Beverage Dispensers
Installation, Operation and Service Manual
Manual load unit
Model U300K
to the appropriate operations person.
801 Church Lane • PO Box D, Easton, PA 18044, USA
Toll free (800) 523-9361 • (888) 2-FOLLETT
(610) 252-7301 • Fax (610) 250-0696 • www.follettice.com
Automatic load unit
with one icemaker
Model U300KR400A/W
Automatic load unit
with two icemakers
Model U300KR800A/W
U L
®
U L
C
®
00109181R00
Advertisement
Table of Contents
Related Manuals for Follett U300K Series
Summary of Contents for Follett U300K Series
- Page 1 Model U300KR800A/W Following installation, please forward this manual to the appropriate operations person. 801 Church Lane • PO Box D, Easton, PA 18044, USA Toll free (800) 523-9361 • (888) 2-FOLLETT ® ® 00109181R00 (610) 252-7301 • Fax (610) 250-0696 • www.follettice.com...
-
Page 3: Table Of Contents
Follett receives the equipment at the factory in Easton, PA within 30 days of the issue of the return authorization number. The equipment must be returned in Follett packaging. If the packaging has been damaged or discarded, Follett will forward, at the customer’s expense, new packaging. -
Page 4: Welcome To Follett Corporation
Before you begin After uncrating and removing all packing material, inspect the equipment for concealed shipping damage. If damage is found, notify the shipper immediately and contact Follett Corporation so that we can help in the filing of a claim, if necessary. -
Page 5: Specifications
Water disconnect within 10 feet (3m) of dispenser is suggested for automatic load units. Follett recommends use of a Follett model AFSYSTMFL4S water filter on icemakers connected to automatic fill dispensers. (detailed specifications may be found in icemaker installation manual... - Page 6 Dimensions and clearances U300 series single-sided dispensers Required clearances 60" (1524mm) minimum above counter for installation if dispenser will be dropped into counter 49" (1245mm) minimum above counter for auger removal 12" (305mm) minimum on ice chute side for service 12"...
-
Page 7: Installation
Installation Installing dispenser in counter Note: All dispensers must be supported from below with supplied 6" - 9" (153 – 229mm) adjustable leg accessory, or equivalent. Do not hang dispenser on flange. All dispensers must be installed level in both directions to ensure proper operation. If dispenser is to be installed in a 34"... -
Page 8: Electrical Connections
Electrical connections Model Electrical connection Circuit(s) required U300K Hard wiring of dispenser required 115V, 60Hz, 1 phase Max. fuse dispenser – 20 amps U300KR400A/W Dispenser power – hard wiring 115V, 60Hz, 1 phase required (2) circuits required Bin signal – cord and plug supplied Dispenser –... -
Page 9: Connecting Beverage Lines
3. For manual load units, remove front drain pan or rear lid and fill storage area with approved ice. Note: Follett manual load dispensers can accommodate most cube/cubelet ices up to 1" square, or Follett compressed nugget ice. Crushed, flake, bagged, nugget or congealed ice cannot be used. Use of these ices can jam dispenser and void warranty. -
Page 10: Operation
In automatic load units, ice is manufactured in either one or two Follett remote icemakers. These icemakers may be located up to 20 ft (6m) away from the dispenser. Extruded ice is transported through a tube and pushed to the storage compartment of the dispenser. -
Page 11: Cleaning
Cleaning Using solutions below, clean and sanitize storage area and beverage lines before starting unit and on a routine basis as noted below. Note: Always disonnect power before cleaning dispenser. Do not run plastic parts through a dishwasher. Combine 1 oz (250ml) bleach with 2 gal (8L) hot water or use Ecolab Mikro-chlor Cleaner Solution A: per manufacturers instructions. - Page 12 Recommended daily dispenser cleaning 1. Remove all debris from drain pan. 2. Pour 1 gallon (4L) hot water into drain pan to keep drain lines clear. Recommended weekly dispenser cleaning 1. Remove drain pan and grille and wash with Solution A. Rinse thoroughly. 2.
-
Page 13: Service
Service Dispense chute assembly Dispense chute cover removal quick release pins gate 1. Remove top cover. gate assembly assembly springs 2. Remove two screws from top cover and pull cover forward and down to remove. 3. On push button units, disconnect plug on harness. Auger motor assembly removal 1. -
Page 14: Wiring Diagrams
Wiring diagrams U300K series AUGER MOTOR DISPENSE PL2-1 PL1-1 PL1-2 PL2-2 BLACK BLACK GRAY ORANGE PURPLE PURPLE BLUE POWER TOP LID DRAIN SWITCH SWITCH SWITCH WHEEL MOTOR PL3-2 PL3-3 PURPLE WHITE BATHPUMP ORANGE MOTOR READY PL5-1 PL5-2 GRAY PUMP BATH CONTROL... -
Page 15: Troubleshooting
(page 17). 4. Check that all drains are clear. Note: For units equipped with Follett compressed nugget icemaker, see Icemaker Operation and Service Manual for service and troubleshooting information. Possible cause... - Page 16 75 psi. excessively carbonated beverages. 2. Dringks may be warm. 2. See “warm drinks” symptom. If problems persist after following this basic troubleshooting guide, call Follett’s technical service department at (800) 523-9361 or (888) 2-FOLLETT or (610) 252-7301.
- Page 17 Operational Status The chart below shows the operational status of various parts when certain switches are turned off or accessories are removed. Condition Pump Solenoids Auger Wheel Beverage valves Top lid off Drain pan off On/off switch in OFF position Beverage switch in OFF position...
-
Page 18: Replacement Parts
Replacement parts Single-side dispenser Plan View Reference # Description Part # Lid, with graphics, single-sided 501930 Graphics, “Follett” 501938 Access panel, tower, single-sided 501944 Not shown Cover, ice opening (below drain pan) 501934 Drain pan assembly and grille 501935 Drain pan, plastic... - Page 19 Top View Top View lower ring auger tube seal reinforcing countertop section Front view auger tube Reference # Description Part # Motor, auger (includes capacitor) 501984 Bracket, auger motor hold-down 502047 Not shown Bracket, auger motor stabilizer 502060 Not shown Seal, shaft, auger motor 501977 Auger...
- Page 20 U300 dispense assembly U300 dispense assembly Side View Top View Reference # Description Part # Gate, dispense 501955 Linkage pin, gate/solenoid 502096 Pin, quick release, 3" (77mm), gate and lever 501949 Chute, ice 501952 Solenoid 501961 Not shown Boot, solenoid 502098 Dispense mechanism assembly 501948...
- Page 21 Reference # Description Part # Ice guide 00111450 Fitting, pump discharge 00111443 Syrup coil 502462 Waterbath ice guide assembly (includes 0011443, 0011450) 00111468 Carbonated water coil, 14" 00107391 Carbonated water coil, 12 1/2" 502461 Pump, waterbath 00111476 Not shown Tubing, vinyl, 1/2" (13mm) ID x 5/8" (17mm) OD (order by the foot –...
- Page 22 Top View ready (orange) BEVERAGE BATH CONTROL BOARD DETAIL Front View Side View HIGH N.O. N.C. INPUT VOLTAGE BEV. BATH INDICATOR WARM COLD COLD CARBONATION LEVEL CONTROL BOARD DETAIL Reference # Description Part # Transformer, 24V 502058 Relay, dispense 501826 Strips, terminal 502472 Switches (power and icemaker)
- Page 24 801 Church Lane • PO Box D, Easton, PA 18044, USA Toll free (800) 523-9361 • (888) 2-FOLLETT 00109181R00 (610) 252-7301 • Fax (610) 250-0696 • www.follettice.com 1/03 ® ®...