Miele G 653 Installation Instructions Manual page 8

Worktops made from hard materials
such as granite or marble do not need
the cover plate for protection. The
cover plate is only used as a guide for
marking the position for the reflector
panel plastic holder.
Keep the cover plate in case the dish-
washer is ever fitted under another type
of worktop.
^ First, remove the protective foil cover-
ing the plastic holder for the reflector
panel and then take the holder out of
the cover plate.
^ Align the cover plate to the front
edge of the worktop in the
the niche. Draw around the cut-out
for the plastic holder.
If the worktop has a
edge, pull the cover plate further for-
ward so that the reflector panel is vis-
ible later.
8
^ Stick the doublesided adhesive strip
supplied onto the back of the plastic
holder.
^ Remove the protective foil from the
adhesive strip and stick the holder to
the underside of the worktop at the
marked position.
of
^ Press the reflector panel into the
plastic holder.