External Water Softening System; Rinse Aid; Check Filters; Adjust Sensor Wash - Miele G 1870 Operating Instructions Manual

External softener
If your dishwasher is connected to an
external water softening system which
uses salt to reactivate, to achieve good
cleaning results you will still need to set
the water hardness level of the water
softening unit on the dishwasher to the
water hardness level of the water
supplied from the external water
softening system.
If you do not know what this is, then set
the value at 1.4 mmol/l (8 °d - German
scale).
^ Select the value which equates to the
water hardness level of the water
supplied by the external water
softening unit and confirm your
OK
selection with
If you disconnect the dishwasher
from the external water softening
system, select the
.
auto
option.
Settings menu J

Rinse aid

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml.
It is set to a recommended setting of
approx. 3 ml at the factory.
If spots appear on crockery and
glassware:
– Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
– Decrease the rinse aid dosage.
^ Use +/-
to select the rinse aid
dosage you want and confirm with
OK
.

Check filters

You can adjust the interval at which the
message to remind you to check the
filters appears.
You can set an interval of between 30
and 60 programme cycles.
The "Check filters" message is set at the
factory to appear after every 40
programme cycles.
^ Select the interval you want and
confirm this with

Adjust sensor wash

You can adjust the sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^ Select the
Yes
OK
with .
OK
.
option and confirm
73