Setting The Rinse Aid Dosage - Miele G 2383 SCVi XXL Operating Instructions Manual

Setting the rinse aid dosage

The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If the Adjust sensor wash function has
been activated, the amount of rinse aid
dispensed could be higher than that set
in the Sensor wash programme.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button U .
Keep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Turbo/Combi tabs button
three times.
The Combi tabs indicator light will flash
briefly three times at intervals.
Before using for the first time
p 3 will flash in the Time display.
This means that the rinse aid dosage
has been set to 3 ml at the factory.
The dosage set will show in the Time
display after the p.
^ Use the programme selector button
to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the Off
button V.
23