Setting The Rinse Aid Dosage - Miele G4930SC Operating Instructions Manual

Before using for the first time

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set in
steps from 0 to 6. The factory default
setting is 3. This is the recommended
setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the
programme.
If spots appear on crockery and
glassware:
 Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
 Decrease the rinse aid dosage.
28
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the Start button in and, whilst
holding it in, switch the dishwasher
on using the  button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
 Press the  button three times.
The  indicator will flash rapidly three
times at intervals.
The dosage set will appear in the
display after .
  will start flashing in the display.
Setting 3 is set (factory default).
 Select required setting with the Start
button.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now stored in memory.
 Switch the dishwasher off with the
 button.