To Programme The Water Hardness Level - Miele G 1270 Operating Instructions Manual

Before using for the first time
To programme the water hardness
level
Each time a button is pressed one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
Off button o. The procedure can
then be re-started from the beginning
again.
^ Switch the dishwasher off using the
Off button o.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Tab button twice.
The "3 in 1" indicator will flash briefly
twice at intervals.
14
The characters "p 1 5" will flash one
after the other in the display.
This means that the water hardness
level has been set at 15 °d (2.7 mmol/l)
(factory setting).
The value which has been set for the
water hardness is shown as a figure
after the "p" in the display (see chart).
Use the programme selector button to
select the value which corresponds to
your water hardness level.
Each press on the button moves you up
a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
^ Switch the dishwasher off with the Off
button o.