Additional Functions; Buzzer - Miele G 1170 Operating Instructions Manual

Operation

Additional functions

Buzzer

An buzzer sounds at the end of the
programme or if there is a fault.
You will hear the buzzer at the end of a
programme in bursts of five with a short
pause in between. The buzzer will
continue to sound for up to an hour if
you do not switch the dishwasher off.
In the event of a fault, the buzzer will
sound continuously for up to two
minutes if you do not switch the
dishwasher off or correct the fault.
The buzzer is activated as standard at
the factory.
You can deactivate the buzzer at the
end of a programme if you wish. The
buzzer will still sound if there is a fault,
even if it has been deactivated.
^ Open the door.
^ Switch the dishwasher off with the Off
button o.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
34
^ Press the programme selector button
briefly four times.
The "Inlet/Drain" check light will flash
briefly four times at intervals.
The upper right hand programme
indicator light shows whether the
buzzer at the end of the programme is
activated or deactivated.
– If the upper right hand programme
indicator is flashing: the buzzer is
activated
– If the upper right hand programme
indicator is not lit up: the buzzer is
deactivated
^ If you want to change the setting,
press the programme selector button
for at least one second until the
"Inlet/Drain" check light comes on.
^ Press the programme selector button
briefly.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button o.