Fault Finding Chart; Environmental Information; Service Recommendations - Flymo Twister 2000 Instruction Manual

WARNING:
Always stop the unit and disconnect the mains electricity supply before performing all of
the recommended remedies below except remedies that require unit to be operating.
FAULT
Unit fails to operate.
Unit vibrates abnormally.
Impeller will not turn freely.

Environmental Information

Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001)
using,where practical,components manufactured in the most environmentally responsible manner, according
to company procedures,and with the potential for recycling at the end of the products' life. Packaging is
recyclable and plastic components have been labelled (where practical) for categorised recycling.
• Awareness of the environment must be considered when disposing of 'end-of-life' product.
• If necessary, contact your local authority for disposal information.
The symbol on the product or on its packaging indicates that this product may not be treated as
household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which could otherwise be caused
by inappropriate waste handling of this product. For more detailed information about recycling of this
product, please contact your local council office, your household waste disposal service or the shop where
you purchased the product.

Service Recommendations

• Your product is uniquely identified by a product rating label.
• We strongly recommend that your product is serviced at least every twelve months.

Fault Finding Chart

CHECK
1. Switch in the OFF position.
2. Mains cable disconnected
from electricity supply.
3. Circuit breaker tripped, or
fuse blown.
4. Mechanical failure.
1. Debris hung on impeller.
2. Mechanical failure.
1. Debris in air intake area or
hung on impeller.
2. Mechanical failure.
ACTION
1. Slide switch to ON position.
2. Reconnect cable.
3. Reset circuit breaker or
fuse.
4. Contact your local Husqvarna
Outdoor Products Approved
Service Centre.
1. Clean unit. Remove any
debris.
2. Contact your local Husqvarna
Outdoor Products Approved
Service Centre.
1. Clean unit. Remove any
debris.
2. Contact your local Husqvarna
Outdoor Products Approved
Service Centre.