Miele DA 5000 D Operating And Installation Manual
Cooker
Hide thumbs
Also See for DA 5000 D:
- Operating and installation instructions (32 pages) ,
- Product dimensions (2 pages) ,
- Operating and installation instructions (32 pages)
Table of Contents
Related Manuals for Miele DA 5000 D
Summary of Contents for Miele DA 5000 D
- Page 1 Operating and installation instructions Cooker hood DA 5000 D en - GB, IRL, ZA To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 4: Warning And Safety Instructions
Any other usage is not supported by This appliance complies with all the manufacturer and could be relevant local and national safety dangerous. Miele cannot be held liable requirements. Inappropriate use for damage resulting from incorrect or can, however, lead to personal injury improper use or operation of the and damage to property. -
Page 5: Technical Safety
(see "After repairs may only be carried out by a Sales Service"). If they do not Miele authorised person in accordance correspond the appliance could suffer with current national and local safety damage. Consult a qualified electrician regulations. - Page 6 Warning and Safety instructions Do not connect the appliance to the Using at the same time as other mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
- Page 7 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... -
Page 9: Correct Installation
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use. -
Page 10: Guide To The Appliance
Guide to the appliance... -
Page 11: Guide To The Appliance
Guide to the appliance Cover plate Touch control for the feature lighting Tower Touch control for hob lighting Canopy This control switches the lighting on The canopy opens as soon as the fan is and off, and is also a dimmer switch. switched on. -
Page 12: Mode Of Operation
Mode of operation The cooker hood works with . . . air extraction: The air is drawn in and cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap which is closed when the cooker hood is switched off. -
Page 13: Miele|Home
The communication module is fitted to hood to be automatically controlled by the cooker hood in the area of the the operating status of a Miele electric motor and is connected to the controls hob with onset controls. of the cooker hood. -
Page 14: Operation
Operation To switch the fan on s Automatic switch-off of the Intensive setting ^ Touch the s sensor. You can set the Intensive setting so that it always only runs for 10 minutes before reverting automatically to level 3. ^ To set this option, both the fan and the hob lighting must be switched off. -
Page 15: Run-On Option "5M15
Operation Hob lighting n Run-on option "5m15" It is advisable to leave the fan running The hob lighting can be switched on for a few minutes after cooking has and off independently of the fan. finished to neutralise any lingering odours in the air. -
Page 16: Feature Lighting ]
Operation Feature lighting ] Reading the grease filter operating hours counter The feature lighting can be switched on and off by touching the ] sensor. To check the percentage of time set already used: ^ Touch the s sensor to switch the fan Safety cut-out ^ Touch and hold the l sensor. -
Page 17: Sensor Control Audible Tones
Operation ^ Touch the "1" sensor to select a Altering the grease filter operating hours counter shorter time and the "4" sensor to select a longer time, until the time You can set the operating hours required has been set. counter to suit the type of cooking you ^ Confirm your selection by touching the l sensor. -
Page 18: Cleaning And Care
Cleaning and care A range of Miele branded cleaning and Do not use: conditioning products is available to – cleaning agents containing soda, order from Miele (see back page for acids, chlorides or solvents, details) or via the internet at www.miele-shop.com. -
Page 19: Grease Filters
Cleaning and care Grease filters To avoid damaging the filters or the The re-usable metal grease filters in the hob below, make sure you hold the appliance remove solid particles filters securely at all times when (grease, dust, etc.) from the kitchen handling them. -
Page 20: Resetting The Grease Filter Operating Hours Counter
Make sure that the spray arm can move freely. ^ Do not wash at more than 65° C. If a Miele dishwasher is being used, select the Sensor wash programme. ^ When the cooker hood is operating, grease residues are deposited in the ^ Use a mild dishwasher detergent. -
Page 21: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp To change the lamps, the canopy needs to be open. ^ Touch the s sensor. The fan will start running at power level 2, and the canopy will open. ^ Touch the "2" sensor for approx. 5 seconds, until the fan switches off. -
Page 22: Changing A Fluorescent Tube
Cleaning and care Changing a fluorescent tube ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. To avoid damaging the glass cover or the hob below, make sure you hold the glass cover securely at all times when handling it. -
Page 23: Appliance Dimensions
650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood. -
Page 24: Installation
Installation Before installation, it is important to read the information given on the following pages as well as the 2 screws M4 x 8 mm for securing the "Appliance dimensions" and the tower. "Warning and Safety instructions" at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same 8 spacers to use in the event of an... -
Page 25: Connection For Air Extraction
Connection for air extraction – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away by at least 1 toxic fumes, please observe the cm per metre. This is to ensure Warning and Safety instructions. that condensate cannot drain back This is especially crucial when using into the cooker hood. - Page 26 Connection for air extraction For exhaust ducting with a diameter of 200 mm, the following accessories are required: – Exhaust grille DFG 200, for mounting on the external wall. *Flashing – Roof ducting DDF 200, for mounting on a sloping tiled roof. –...
-
Page 27: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a... -
Page 28: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can Installation be used to combine the cooker hood with other components. It enables the following: Potential free connection This can be used to operate a further appliance via the On/Off button s on the cooker hood. -
Page 29: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer please contact Miele. See back cover for contact details. In the U.K. your appliance is – The Miele Customer Contact Centre guaranteed for 2 years from the date of (see back cover for address). -
Page 30: Technical Data
Technical data Total connected load..632 W – Fan motor ....500 W – Canopy mechanism ... 4 W –... - Page 32 Alteration rights reserved / 3011 M.-Nr. 09 202 570 / 00...