Table of Contents
Related Manuals for Miele DA 5390 W
Summary of Contents for Miele DA 5390 W
- Page 1 Operating and installation instructions Cooker hood DA 5390 W, DA 5320 W en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 4: Warning And Safety Instructions
Any other usage is not supported by This appliance complies with all the manufacturer and could be relevant local and national safety dangerous. Miele cannot be held liable requirements. Inappropriate use for damage resulting from incorrect or can, however, lead to personal injury improper use or operation of the and damage to property. -
Page 5: Technical Safety
(see "After repairs may only be carried out by a Sales Service"). If they do not Miele authorised person in accordance correspond the appliance could suffer with current national and local safety damage. Consult a qualified electrician regulations. - Page 6 Warning and Safety instructions Do not connect the appliance to the Using at the same time as other mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
- Page 7 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... -
Page 9: Correct Installation
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use. -
Page 10: Guide To The Appliance
Guide to the appliance... -
Page 11: Guide To The Appliance
3 panels are required for the To activate the run-on option. The fan DA 5390 W, and 4 panels for the can be set to continue running, and to DA 5320 W. switch off automatically after either 5 or Control panel 15 minutes. -
Page 12: Mode Of Operation
Mode of operation The cooker hood works with . . . air extraction: The air is drawn in and cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap which is closed when the cooker hood is switched off. -
Page 13: Miele|Home
Miele electric hob with onset controls. This module must be installed by a For communication to take place, the... -
Page 14: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off control. ^ To set this option, both the fan and the hob lighting must be switched off. -
Page 15: Run-On Option
Operation Run-on option It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering The indicator lamps for fan power levels odours in the air. I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15... -
Page 16: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the hob lighting control ^ Pressing the On/Off control will to switch on the hob lighting. -
Page 17: Filter Operating Hours Counter
Operation Filter operating hours counter Reading the filter operating hours counter The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filters need to be cleaned. - Page 18 Operation Altering the filter operating hours counter The filter operating hours counter is set at 30 hours. This can be lengthened or The – / + indicator lamps show the time shortened to suit the type of cooking which has been set: you do.
-
Page 19: Cleaning And Care
Cleaning and care A range of Miele branded cleaning and Do not use too much water when conditioning agents are available to cleaning the controls. Water could order through your Miele Dealer / Chartered Agent, the Miele Spare Parts penetrate into the electronics and Department, or via the internet on cause damage. -
Page 20: Grease Filters
Cleaning and care Important for appliances with An oversaturated filter is a fire lacquered housing hazard. (special order finish) If decor panels are fitted as an optional It is very difficult to clean this type of extra, these need to be removed first. surface without causing minor marks to the surface material. - Page 21 ^ Do not wash at more than 65° C. If a approximately 3 seconds to reset the Miele dishwasher is being used, operating hours counter. select the Sensor wash programme. The indicator lamp will go out.
-
Page 22: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them. -
Page 23: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –... -
Page 24: Appliance Dimensions
Appliance dimensions DA 5390 W DA 5320 W... -
Page 25: Safety Distance Between Hob And Cooker Hood (S)
650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood. -
Page 26: Installation
Installation Assembly parts... - Page 27 Installation 3 protective sheets for use when fitting the tower. 2 hose clips 2 screws 3.9 x 7.5 mm for securing the exhaust ducting. for securing the tower. 1 reducing collar for exhaust ducting C 150 mm. Telescopic wall bracket for securing the cooker hood to the wall.
-
Page 28: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 29: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 30: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 Control module can Installation be used to combine the cooker hood with other components. It enables the following: Potential free connection This can be used to operate a further appliance via the On/Off button s on the cooker hood. -
Page 31: Connection For Air Extraction
Connection for air extraction Important: To avoid the danger If the exhaust ducting is secured to of toxic fumes, please observe the the exhaust stub by a hose clip, Warning and Safety instructions. ensure that it is fitted correctly and is This is especially crucial when using not askew. - Page 32 Connection for air extraction For exhaust ducting with a diameter of 200 mm, the following accessories are required: – Exhaust hose DAS 200 – Exhaust grille DFG 200, for mounting on the external wall. *Lead flashing – Roof ducting DDF 200, for mounting on a sloping tiled roof.
-
Page 33: Technical Data
Total connected load - DA 5390 W ....580 W - DA 5320 W ....600 W Fan. - Page 36 Alteration rights reserved / 3011 M.-Nr. 09 203 400 / 00...