Table of Contents
Advertisement
Electrical connection
All electrical work should be under-
taken by a competent person in
strict accordance with national and
local safety regulations.
Connection of this appliance should be
made via a suitable isolator which com-
plies with national and local regula-
tions, and which is accessible after the
appliance has been built in.
The
are given on the data plate, located at
the rear of the appliance. Please en-
sure that these match the household
mains supply.
Please quote these data, and the
model and serial number when contact-
ing the Miele Service dept.
A second data plate is also supplied.
For extra safety it is advisable to install
a residual current device with a trip cur-
rent of 30 mA.
The appliance is supplied with a 3-core
cable for connection to a 230-240 volt
50 Hz supply.
The wires are coloured in accordance
with the following code:
Green/yellow = earth
Blue
= neutral
Brown
= live
10
Q\}
Q\}
If the connection requires a different
cable, the Miele Service dept must
be consulted.
See the data plate for the maximum
rated load.
The hob control units may only be com-
bined with one of the hobs listed below,
(not all units are available in every
country):
KM 220
KM 221
KM 222
KM 230
KM 232
KM 240
KM 242
KM 243
KM 245
KM 246
KM 247
KM 248
KM 251
KSE 200
KSE 202-1
KSE 204-1
Advertisement
Table of Contents
