Safe Use Of This Product - YOKOGAWA DpharpEJX vigilantplant EJX110 User Manual

• The following safety symbols are used in this
manual:
WARNING
Indicates a potentially hazardous situation which,
if not avoided, could result in death or serious
injury.
CAUTION
Indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate
injury. It may also be used to alert against
unsafe practices .
IMPORTANT
Indicates that operating the hardware or software
in this manner may damage it or lead to system
failure.
NOTE
Draws attention to information essential for
understanding the operation and features.
Direct current
1.1

Safe Use of This Product

For the safety of the operator and to protect the
instrument and the system, please be sure to follow this
manual's safety instructions when handling this
instrument. If these instructions are not heeded, the
protection provided by this instrument may be im-
paired. In this case, Yokogawa cannot guarantee that
the instrument can be safely operated. Please pay
special attention to the following points:
(a) Installation
• This instrument may only be installed by an engi-
neer or technician who has an expert knowledge of
this device. Operators are not allowed to carry out
installation unless they meet this condition.
• With high process temperatures, care must be taken
not to burn yourself by touching the instrument or
its casing.
• Never loosen the process connector nuts when the
instrument is installed in a process. This can lead to
a sudden, explosive release of process fluids.
• When draining condensate from the pressure
detector section, take appropriate precautions to
prevent the inhalation of harmful vapors and the
contact of toxic process fluids with the skin or eyes.
• When removing the instrument from a hazardous
process, avoid contact with the fluid and the interior
of the meter.
• All installation shall comply with local installation
requirements and the local electrical code.
(b) Wiring
• The instrument must be installed by an engineer or
technician who has an expert knowledge of this
instrument. Operators are not permitted to carry out
wiring unless they meet this condition.
• Before connecting the power cables, please confirm
that there is no current flowing through the cables
and that the power supply to the instrument is
switched off.
(c) Operation
• Wait 5 min. after the power is turned off, before
opening the covers.
1-2
1. INTRODUCTION
IM 01C25B01-01E