Download Print this page
Teledyne 3000MA Instruction Manual
Teledyne 3000MA Instruction Manual

Teledyne 3000MA Instruction Manual

Percent oxygen analyzer
Hide thumbs Also See for 3000MA:

Advertisement

Quick Links

Additional Operating
instructions and/or
information for your
Model 3000MA
Percent Oxygen
Analyzer
Addendum for Model 3000MA Percent Oxygen Analyzer
Q002870
The instruction manual included with your analysis system from
Teledyne Analytical Instruments describes the standard features of
the system. Refer to the manual for information regarding all
standard features of the model that you have selected.
In addition, your specific system has been designed according to the
needs that you specified at the time of purchase. The information
contained in this addendum addresses those needs and supersedes
any conflicting instructions and descriptions in the standard
instruction manual.
NOTE: All drawings that relate to your system are at the rear of
this manual.
System Overview
The Model 3000MA Percent Oxygen Analyzer is configured with a
Paramagnetic sensor and auto cal valves. This instrument has a
general purpose area class.
Power Requirements
This instrument operates from a power source of 220 VAC at 50/60
Hz.
Analysis Range
The Model 3000MA has three user defined analysis ranges of 0-5 to
0-100 Percent Oxygen (O
Signal Outputs
This Model 3000MA has a signal output of 4-20mA isolated.
Teledyne Analytical Systems
).
2
C.O. 85723
Page 1

Advertisement

loading

Summary of Contents for Teledyne 3000MA

  • Page 1 Power Requirements This instrument operates from a power source of 220 VAC at 50/60 Analysis Range The Model 3000MA has three user defined analysis ranges of 0-5 to 0-100 Percent Oxygen (O Signal Outputs This Model 3000MA has a signal output of 4-20mA isolated.
  • Page 2: Reference Drawings

    Addendum for Model 3000MA Percent Oxygen Analyzer Software The software for this instrument adds hold timers for span and zero calibration; each calibration has its own timer separate timer. Span Delay: By pressing the Span key, the operator accesses the setup mode of the span calibration.