Specifications - Mitsubishi HS-1024E Installation And Operation Manual

Specifications

General
Power Source : AC 100-230 V
Power Consumption : Approx. 18 watts
Television System : CCIR standard 625 lines, 50 field PAL-
type colour system
Colour Signal : Low frequency conversion, sub-carrier
phase shift recording
Tape Format : VHS 1/2" width high-density video
cassette tape
Tape Speed and Recording : See below (*1)
Fast Forward/Rewind Time : Approx. 120 seconds with E-180 tape
Operating Temperature : 41 F to 104 F (5 C to 40 C)
Relative Humidity : Max. 80 %
Dimensions (Jog dial included) : 16.7 (W) x 12.4 (D) x 3.7 (H) (in.)
425 (W) x 314 (D) x 95 (H) (mm)
Weight : 9 lbs (4.2 kg)
Heads-Video : 4 rotary heads
Luminance Signal : Frequency modulation recording
Audio Track : 1 track
Audio/Control : 1 stationary head
Erase : 1 full-track head
Motors : 3 motors-drum/capstan direct drive
system
Battery Backup : Lasts 31 days
Weight and dimensions shown are approximate.
Design and specifications are subject to change without notice.
(*1)
Tape Speed and Recording Time (with E-180 cassette):
Mode Time
3H (SP) 3 h 23.39 mm/s
L12H (SP) 15 h
L24H (SP) 27 h
Note
If the VCR is not working correctly or showing an unusual indication on the fluorescent display, press RESET button at the rear panel with a pointed
instrument. When pressed, Date/Present time/ALARM LIST/POWER LOSS LIST/Counter display/Recording and Playback mode will be set to the
default setting and the VCR turns off.
To restart the VCR, press POWER button to turn on the VCR and then set the day and present time.
Reference page
10%, 50/60 Hz
Speed Recording Interval
0.0200 s/Field
4.68 mm/s 0.100 s/Field
2.60 mm/s 0.180 s/Field
Audio
Input
Output
Signal-to-Noise Ratio
Frequency Response
Video
Input
Output
Signal-to-Noise Ratio
Horizontal Resolution
Connectors
ALM Input : Screw terminal for starting alarm recording
RST Input : Screw terminal for finishing alarm recording or for
adjusting on-screen clock
REC Input : Screw terminal for starting/finishing recording or for
series recording
GND : Screw terminal for ground
ALM Output : Screw terminal for output while alarm recording is
under way
CLK Output : Screw terminal to command camera switching
MODE Output : Screw terminal for indication of VCR selected mode
CALL Output : Screw terminal for external warning device or for
series recording
Recording Fields
Video Signal
per Second
50 fields/s Continuous
10 fields/s Time Lapse
5.6 fields/s Time Lapse
: 308 mV (rms), 50 k , RCA plug
: 388 mV (rms), 1 k , RCA plug
: Better than 43 dB
: 70 Hz - 7 kHz (3H mode)
: 1.0 V (p-p), 75 BNC plug
: 1.0 V (p-p), 75 , BNC plug
: Better than 42 dB
: More than 330 lines (Black & White)
More than 240 lines (Colour)
Audio Signal Tape Drive
Recordable Continuous
Recordable Continuous (Slow)
Recordable Continuous (Slow)
Others
31