Changing The Auto Power Off Setting; Setting Image Reverse; Correcting Skewed Or Distorted Image - Mitsubishi Electric DLP NW30U User Manual

Setting up your projector (continued)
Changing the AUTO POWER OFF
setting
The AUTO POWER OFF function of this projector is
enabled by default.
Change the AUTO POWER OFF setting as necessary.
(See page 29.)
To change the AUTO POWER OFF setting:
(See page 26 for menu setting.)
1. Display the INSTALLATION menu.
2. Select AUTO POWER OFF by pressing the  or 
button.
AUTO POWER OFF
3. Select your desired item by pressing the  or 
button.
Important:
• This function does not work when the input source
is LAN DISPLAY or USB VIEWER.
• The AUTO POWER OFF function does not work
during AV MUTE.
• While the intelligent glare sensor is detecting an
object, AUTO POWER OFF doesn't work. (When
the intelligent glare sensor stops detecting, the
projector turns off.)
Setting HIGH ALTITUDE MODE
• Set HIGH ALTITUDE MODE in the FEATURE menu
according to the altitude at which you use the
projector. The default setting is STANDARD.
• Select STANDARD when using the projector at an
altitude from 0 to 1500 meters.
• Select HIGH ALTITUDE when using the projector at
an altitude from 1500 to 2700 meters.
Important:
• If you select STANDARD when using the projector
at an altitude higher than 1500 meters, the
projector may break down or fail.
• When you use the projector in the HIGH ALTITUDE
mode, only fl oor installation and ceiling installation
are allowed.
(See page 26 for menu setting.)
1. Display the FEATURE menu.
2. Select HIGH ALTITUDE MODE by pressing the 
or  button.
HIGH ALTITUDE MODE
3. Press the ENTER button.
HIGH ALTITUDE MODE
HIGH ALTITUDE MODE
4. Select STANDARD
pressing the  or  button.
5. Press the ENTER button.
5min
STANDARD
STANDARD
or HIGH ALTITUDE by

Setting IMAGE REVERSE

Set IMAGE REVERSE in the INSTALLATION menu
according to the orientation of the projector. The
default setting is OFF.
• Select OFF for the combination of fl oor installation
and front projection.
• Select MIRROR INVERT for the combination of
ceiling installation and front projection.
• Select MIRROR for the combination of fl oor
installation and rear projection.
• Select INVERT for the combination of ceiling
installation and rear projection.
(See page 26 for menu setting.)
1. Display the INSTALLATION menu.
2. Select IMAGE REVERSE by pressing the  or 
button.
IMAGE REVERSE
3. Select OFF, MIRROR, INVERT or MIRROR INVERT
by pressing the  or  button.
Correcting skewed or distorted
image
For the best projection, project images on a fl at screen
installed at 90 degrees to the fl oor. If necessary, tilt the
projector using the two adjustment feet on the bottom
of the projector.
1. Tilt up the projector to the appropriate angle.
2. Rotate the adjustment feet for fi ne adjustment.
Important:
• Don't transport the projector with its adjustment
feet extended. Otherwise the adjustment feet may
be damaged.
When fi ne streaks are seen on
projected images
This is due to interference with the screen surface and
is not a malfunction. Replace the screen or displace
the focus a little.
EN-12
OFF
Adjustment feet
Screen