Advertisement
.354"
9
• Fit a .354" cap nut onto the end of the front axle.
• Cover the cap nut with the assembly tool. Tap the cap nut assembly
tool with a hammer to secure the cap nut to the front axle.
• Pull on the small, front wheel to be sure it is secure on the front axle.
10
• Fit an axle cover to the small, front wheel, as shown.
• Push the axle cover to "snap" it into place.
Hint: You may need to carefully tap the axle covers with a hammer
to secure in place.
• Repeat assembly steps 6-10 to assemble a
bushing, small, front wheel, wheel bushing, .354" cap nut and axle
cover to the other front axle.
Assembly Tool
.354"
Cap Nut
Axle Cover
5
/
" washer, axle
16
Assembly
Back End of Frame
Tabs
11
Rear Side View
• Lift the back end of the
frame up slightly.
• Position the bouncer
base/spoiler so that the
columns are upright and
the "U" shaped cut-out is toward the back of the vehicle.
• Now, lower the back end of the frame onto the bouncer base/spoiler
tabs. Make sure the tabs on the bouncer base/spoiler fit into the
grooves in the frame.
Frame Bushing
12
• Fit the frame bushings into the slots in the back end of the frame.
Hint: The frame bushings are designed to fit in the slots one way!
If the frame bushing does not fit in the slot, turn it around and try again.
6
Groove
Bouncer Base/Spoiler
"U" Shaped Cut-Out
Back View
Frame Bushing
Advertisement
