Table of Contents
Advertisement
Chapter 1. Installing an AMCC 3ware 9590SE RAID Controller
Additional Details About the LED Status
Connectors
As shown in Figure 10 through Figure 12, LED connectors for
individual drives are on J7, J8, J3, and J4 for the 16 port card, on J7,
J8, and J3 for the 12-port cards, and on J7 and J8 for the 8-port.
Pin 1 is located in the lower left-hand corner of each 10-pin
connector. The odd-numbered pins, located on the bottom row, are
3.3V for the anode (+) side of each LED to be connected. The even-
numbered pins are on the top or cathode (-) side.
Table 1 summarizes the LED indicator pin positions for the
different controllers.
Warning:
LED ground, be sure to only connect LED cables to the
anode pins on the controller. Do not connect any common
ground to any cathode pins on the controller.
Table 1: LED Indicator Pin Positions
Controller
9590SE-8ML
18
3ware 9590SE Serial ATA RAID Controller Quick Install Guide
If using a chassis that has a common or shared
LED
Pin Pair
Header
J7
: : : : :
0 1 2 3 All
J8
: : : : :
4 5 6 7 All
k-cathode-minus is on the top
a-anode-plus is on the bottom
Comment
Orientation Horizontal
Port number/All
(all activity indicator)
Orientation Horizontal
Port number / NU
(Not Used)
Advertisement
Table of Contents
