Initial Tab Copy Setting; Setting A Maximum Number Of Copies; Disabling Deletion Of Job Programs; Disabling Of Bypass-Tray In Duplex Copy - Sharp AR-M550N Key Operator's Manual

PROGRAMS FOR COPY MODE

Initial tab copy setting

This program is used to set the initial image shift width
(tab width) for tab copying.
The width can be set from 0 mm to 20 mm (0" to 5/8")
in increments of 1 mm (1/8").
Tab width

Setting a maximum number of copies

This program is used to set the maximum number of
copies that are allowed per original.
Any number from 1 to 999 can be set for the maximum.
The maximum number of copies is initially set to 999.

Disabling deletion of job programs

This program is used to prohibit the deletion and
changing of copy settings stored in job programs.

Disabling of bypass-tray in duplex copy

This program is used to disable the use of the bypass
tray when making duplex copies.
The bypass tray is often used to feed label sheets,
transparency film, and other special papers for which
two-sided copying is prohibited. If one of these special
papers enters the reversing unit, a misfeed or damage
to the unit may result. If special papers for which
two-sided copying is prohibited are often used, it is
recommended that you enable this program to prevent
feeding of special papers from the bypass tray into the
reversing unit during two-sided copying.

Disabling of auto paper selection

This program is used to disable the auto paper
selection function.
When this program is enabled, paper that is the same
size as the original placed on the document glass or in
the automatic document feeder is not automatically
selected.
15