Sharp UX-B30 Operation Manual page 76

Caller ID (Requires Subscription to Service)
Note: For all units installed in New Zealand, the direct use of the displayed
number for call back does not operate properly and must not be used. It is
necessary to manually enter the verified correct number for the party called.
This will often require the addition or deletion of leading digits from the
number shown on the display when dialling manually.
♦
After you have received 30 calls, each new call will delete the oldest call.
♦
All calls will be erased if you unplug the fax or a power failure occurs.
Follow the steps below to view the Caller ID List in the display. If desired, you
can immediately dial a number when it appears.
1
Press twice.
2
Press
3
If you wish to dial one of the numbers in the list, scroll through the list
until the number appears in the display.
•
Fax: If you wish to send a fax, load the
document and then press
Dialling and transmission begin.
•
Voice call: If you wish to make a voice
call, pick up the handset (or press
Dialling begins automatically. (If you
pressed
the other party answers.)
4
Press
74
or to scroll through the list.
MEMORY
, pick up the handset when
when you have finished viewing the list.
START/
. Fax:
).
<REVIEW CALLS>
Voice
call:
START/
MEMORY