Honda 2008 Pilot Owner's Manual page 262

Lights
Replacing a Side Turn Signal Bulb
CLIPS
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the left, and turn off the engine.
If you are changing the bulb on
the passenger's side, turn the
steering wheel to the right.
2. Use a flat-tipped screwdriver to
remove the three holding clips
from the inner fender.
256
SOCKET
3. Pull the inner fender cover away
from the fender.
4. Remove the socket from the turn
signal assembly by turning it one-
quarter turn counterclockwise.
5. Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.
6. Insert the socket back into the
turn signal assembly. Turn it
clockwise to lock it in place.
7. Turn on the lights to make sure
BULB
the new bulb is working.
8. Put the inner fender cover in place.
Install the three holding clips.
Lock each clip in place by pushing
on the center.