Table of Contents
Advertisement
Supplementary Notes
How to connect the VM-3100Pro and
the ADA-7000
Connection
Connect the VM-3100Pro and the ADA-7000 with the R-BUS cable attached in the ADA-7000 box.
Booting up
Turn the power on the ADA-7000 first, then VM-3100Pro.
Sampling clock setting
If clock source has not been set, noise may be generated from the audio output on the ADA-7000 and the VM-
3100Pro. While setting the clock source, please turn down the master and monitor level, and turn up again after the
setting is finished. Set the sampling clock of the ADA-7000 and the VM-3100Pro as follows.
Clock Source on the ADA-7000:
Master clock on the VM-3100Pro:
ADA-7000 setting
Check if the clock source on the ADA-7000 is set to R-BUS. When the ADA-7000 is booted up, the clock source is set
to R-BUS.
* Refer to ADA-7000 Owner's Manual p. 6 "Clock source."
VM-3100Pro setting
Set the master clock of the VM-3100Pro to INTERNAL as follows.
1.
Hold down [SHIFT], and press [DIGITAL IN].
2.
Press [F1 ( INT)].
* Sample rate of the VM-3100Pro is fixed to 44.1kHz. If you use the VM-3100Pro and the ADA-7000 in combination,
the ADA-7000 works in 44.1kHz sample rate.
* If you set the clock source differently, please refer to the
ADA-7000 Owner's Manual p. 6 "Clock source" and the
VM-3100Pro Owner's Manual p. 52 "Inputting signals from digital devices."
How to connect the VSR-880 and the ADA-7000
Connection
Connect the VSR-880 and the ADA-7000 with the R-BUS cable attached in the ADA-7000 box.
Booting up
Turn the power on the ADA-7000 first, then VSR-880.
Sampling clock setting
Set the sampling clock of the ADA-7000 and the VSR-880 as follows. If clock source has not been set, noise may be
generated from the audio output on the ADA-7000 and the VSR-880. While setting the clock source, please turn
down the master and monitor level, and turn up again after the setting is finished.
Clock Source on the ADA-7000:
Master clock on the VSR-880:
18
R-BUS
INTERNAL
R-BUS
INTERNAL
Advertisement
Table of Contents
