Table of Contents
Advertisement
Front and Rear Panels
TERMINATOR Switch:
Turn this on if the ADA-7000 is the last device in the word clock signal chain. Normally
you will leave this turned on. Turn this off only if you are using a relay connector to
distribute the word signal to other devices.
fig.3a.e
Sampling Clock Master
Digtal Tape Recorder
TERMINATOR
SWITCH: OFF
CLOCK SOURCE: WORD CLOCK
OUT:
This outputs the sampling clock on which the ADA-7000 is operating. Use this when you
want another device to synchronize to the sampling clock on which the ADA-7000 is
operating.
3 R-BUS (RMDB2) Connector
This is an 8-in/8-out 24 bit digital audio connector. Connect it to another device that has
an R-BUS connector (e.g., Roland digital mixer or Roland digital recorder).
4 RCA OUTPUT Connectors 1–8 (-10 dBu)
Connect an RCA phono type plug here to output the same analog signal (+4 dBu) as from
the XLR output (converted to consumer level).
5 XLR/TRS INPUT Connectors 1–8
Connect either an XLR type or TRS phone plug (not both) here to input an analog signal.
Phantom power can be supplied to the XLR input jacks. To turn the phantom power on/
off, use the front panel PHANTOM buttons.
* Always turn the phantom power off when connecting any device other than condenser
microphones that require phantom power. You risk causing damage if you mistakenly supply
phantom power to dynamic microphones, audio playback devices, or other devices that don't
require such power. Be sure to check the specifications of any microphone you intend to use by
referring to the manual that came with it.
(This instrument's phantom power: 48 V DC, 14 mA/ch Max)
6 XLR OUTPUT Connectors 1–8
Connect an XLR type plug here to output the analog signal (+4 dBu).
10
Connector
WORD CLOCK IN
ADA-7000
Connect the R-BUS (RMDB2) connector only to an R-BUS equipped device.
To avoid malfunctions, never connect it to a SCSI connector, an RS-232C
connector, or a parallel connector, even if the connector has the same
shape. Use a special R-BUS (RMDB2) cable to make connections.
RMDB II, RMDB2 and R-BUS are the same standard of Roland corporation.
WORD CLOCK IN
WORD CLOCK SLAVE
Advertisement
Table of Contents
