Fisher-Price CATERPILLAR 78656 Owner's Manual & Assembly Instructions page 12

9
Headlight Guard
• Using safety scissors, separate the round headlight
guards from the plastic connector. Dispose of the plastic
connector.
• Fit the tabs on the back of the headlight guards into the
slots in the front of the hood.
• Push firmly to snap the tabs into the hood.
10
1
2
Large Hole
3
• Fit together the two halves of the exhaust stack
• Insert two #6 x 1 1 / "" screws into the exhaust stack
2
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Fit the end of the exhaust stack into the large hole in the
top of the vehicle body and push firmly until it snaps into
the vehicle body 3 .
Assembly
Exhaust Stack Halves
1
.
2 .
11
• Turn the vehicle body on its side.
• Align the hole in the wire retainer with the screw peg in
the underside of the vehicle body, near the footswitch.
• Insert a #8 x 1 / " screw through the wire retainer and into
2
the vehicle body.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
12
• Place the wiring between
the ends of the wire
retainer.
• Twist the ends of the wire
retainer together to hold the
12
wiring against the vehicle
body.
Bottom View Footswitch
Bottom View
Wire Retainer Ends
Twisted Together
Wire
Retainer
Screw
Peg
Wire
Retainer
Ends