Fisher-Price CATERPILLAR 78656 Owner's Manual & Assembly Instructions page 11

5
Front
Wheel
Axle
Hubcap
Bushing
Peg
• Slide a 7 / " washer onto one of the front axles.
16
• Slide an axle bushing onto the front axle. Make sure the
axle bushing is positioned as shown in the illustration,
with the ring facing the washer.
• Slide a front wheel onto the front axle. Make sure that
the peg on the wheel is facing away from the
axle bushing.
• Slide a hubcap onto the front axle.
• Rotate the hubcap to make sure it is fully seated inside
the center of the wheel.
6
Large Cap Nut
Front Axle
• Fit a large cap nut on the end of the front axle.
• Tap the cap nut gently with a hammer to secure it on the
end of the axle.
• Pull on the wheel to make sure the cap nut is firmly
attached to the front axle.
• Repeat assembly steps 5 and 6 to assemble the other
front wheel.
Assembly
Peg
Ring
Vehicle Body
Washer Front Axle
7
Grille
• Face the front of the vehicle.
• Fit the tabs extending from the bottom of the grille into
the rectangular slots above the front bumper.
• Push on the grille to snap the tabs on the back of the
grille into the slots in the front of the vehicle body.
8
16
• Align the slots in the headlight labels with the headlight
guard slots in the hood. Apply the headlight labels
as shown.
• Make sure the areas where the labels will be applied are
clean and dry. For best adhesion, avoid repositioning the
labels once they are applied to the vehicle.
11
Bottom
Tabs
Slots
Front Bumper
16