Identify Device Command - Seagate DB35.2 Serial ATA Product Manual

4.3.1

Identify Device command

The Identify Device command (command code EC
power up. The data is organized as a single 512-byte block of data, whose contents are shown in Table 7 on
page 29. All reserved bits or words should be set to zero. Parameters listed with an "x" are drive-specific or
vary with the state of the drive. See Section 2.0 on page 3 for default parameter settings.
The following commands contain drive-specific features that may not be included in the Serial ATA specifica-
tion.
Word Description
Configuration information:
• Bit 15: 0 = ATA; 1 = ATAPI
0 • Bit 7: removable media
• Bit 6: removable controller
• Bit 0: reserved
1 Number of logical cylinders
2 ATA-reserved
3 Number of logical heads
4 Retired
5 Retired
6 Number of logical sectors per logical track: 63
7–9 Retired
10–19 Serial number: (20 ASCII characters, 0000
20 Retired
21 Retired
22 Obsolete
23–26 Firmware revision (8 ASCII character string, padded with blanks to end
of string)
27–46 Drive model number: (40 ASCII characters, padded with blanks to end
of string)
47 (Bits 7–0) Maximum sectors per interrupt on Read multiple and Write
multiple (16)
48 Reserved
49 Standard Standby timer, IORDY supported and may be disabled
50 ATA-reserved
51 PIO data-transfer cycle timing mode
52 Retired
53 Words 54–58, 64–70 and 88 are valid
54 Number of current logical cylinders
55 Number of current logical heads
56 Number of current logical sectors per logical track
DB35.2 Serial ATA Product Manual, Rev. C
) transfers information about the drive to the host following
H
= none)
H
Value
0C5A
H
16,383
0000
H
16
0000
H
0000
H
003F
H
0000
H
ASCII
0000
H
0400
H
0000
H
x.xx
ST3500841SCE
ST3400833SCE
ST3300822SCE
ST3250824SCE
ST3200827SCE
ST3160212SCE
ST3120213SCE
ST3802110SCE
8010
H
0000
H
2F00
H
0000
H
0200
H
0200
H
0007
H
xxxx
H
xxxx
H
xxxx
H
31