Advertisement
Assembly
Frame
Decorated
Side
Back Base Hole
Screw
Retainers
9
7
#10 x
/
" Black Screw - 2
8
SHOWN ACTUAL SIZE
• Position a frame so that the decorated side is outward.
• Insert the back leg of a frame into the back base.
• Fit a screw retainer over the hole in the back base, as shown.
7
• Insert a #10 x
/
" black screw through the screw retainer
8
and back base.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other frame back leg to
the other side of the back base.
Frame
Back
Legs
Back Base Hole
Screw Retainer - 2
Seat Height
Adjusters
Press Lever
10
• While pressing the levers on the seat height adjusters, lift
them to position 4 on the frame front legs, as shown.
Sockets
11
• Fit the seat assembly between the two frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position
(position 4).
• You may need to push the frames apart slightly to fit the seat
bottom tubes into the seat height adjuster sockets.
6
Position 4
Seat Assembly
Sockets
Seat Bottom
Tubes
Advertisement
