Advertisement
Assembly
Frame
Decorated
Side
Base Hole
Screw
Retainers
8
7
#10 x 2.2 cm (
/
")
8
Black Screw - 2
SHOWN ACTUAL SIZE
• Position a frame so that the decorated side is outward.
• Insert the back legs of a frame into one of the bases.
• Fit a screw retainer over the hole in the base, as shown.
7
• Insert a #10 x 2.2 cm (
/
") black screw into the screw
8
retainer and tighten.
• Repeat this procedure to fasten the other frame back leg
to the other side of the base with a screw retainer and
7
#10 x 2.2 cm (
/
") black screw.
8
7
Hint: The #10 x 2.2 cm (
/
") black screws may have been
8
assembled to the screw retainers.
Frame
Back
Legs
Base Hole
Screw Retainer - 2
6
Seat Height
Adjusters
Press Lever
9
• While pressing the levers on the seat height adjusters, lift
them to position 4 on the frame front legs, as shown.
Sockets
Seat Bottom
10
• Fit the seat assembly between the two frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position
(position 4).
• You may need to push the frames apart slightly to fit the seat
bottom tubes into the seat height adjuster sockets.
Position 4
Seat Assembly
Sockets
Tubes
Advertisement
