Zone Dir Set; Zone Area; Location; Zone Id Set - Samsung SCC-C6407 Owner's Instructions Manual

00600A-SCC-C6407-ENG 8/17/06 3:27 PM ˘` 3-23

ZONE DIR SET

Press the [Enter] key in the "ZONE DIR SET ON..." mode to enter the
NORTH SET screen. MAP. Move PAN to set the NORTH location and
press [ENTER]. Based on the North location,the direction of N(North),
NE(North-East), E(East), SE(South-East), S(South), SW(South-West),
W(West), NW(North-West) is displayed whenever you move PAN.
(ZONE SET)
PRIVACY ZONE ...
ZONE DIR SET ON...
ZONE AREA SET OFF
EXIT QUIT

ZONE AREA

Press [ENTER] to enter the ZONE AREA MAP screen from "ZONE
AREA SET...". Select a ZONE AREA number from the ZONE AREA MAP
screen and press [ENTER] to enter the ZONE AREA setup screen.
(ZONE SET)
PRIVACY ZONE ...
ZONE DIR SET OFF
ZONE AREA SET ON...
EXIT QUIT
ZONE AREA SET 0

LOCATION

ZONE ID SET

ZONE ENABLE

Press
[Enter]
EXIT
3-23
SET NORTH
N
Press
[Enter]
(ZONE AREA MAP)
0 * 1 2 3
4 5 6 7
Press
[Enter]
RET
...
...
ON
QUIT
LOCATION
The "LOCATION..." menu designates the left/right LIMIT positions of
ZONE AREA. Enter the setup screen to move PAN, then select a start
location and press [ENTER]. Move PAN again
to select a end location and press [ENTER]. Now, ZONE AREA setup is
complete.
ZONE AREA SET 0
LOCATION ...
ZONE ID SET ...
ZONE ENABLE ON
Press
[Enter]
EXIT QUIT
SET END!
After PAN control,
press [ENTER] to
finish.
ZONE ID SET
This function is used to allocate as many as 12 IDs to each zone area.
Use Left , Right, UP, or DOWN for this purpose. You may select the ID
location from the additional menu of "LOCATION...".
ZONE AREA SET 0
LOCATION ...
ZONE ID SET ...
ZONE ENABLE ON
Press
[Enter]
EXIT QUIT
ZONE ENABLE
This function turns on or off the ZONE AREA ID indication.
SET START!
After P/R/Z
control, press
[ENTER]
ZONE AREA ID 0
A B C D E F G H I J K L
M N O P Q R S T U V W X
Y Z 0 1 2 3 4 5 6 7 8 9
: ! - + ( ) /
SP ï î SP
LOCATION...
RET
ZONE 0........
3-24
E