Error Messages - Korg microSAMPLER Owner's Manual

Sample parameters
LEVEL
VEL INT (Velocity Intensity)
PAN
FX SW
ORIG BPM (Original BPM)
ORIG.RATE (Original Rate)
DEL SMPL
SWAP.SMPL
LOAD.SMPL
NORMALIZ (Normalize)
TRUNCATE
Pattern sequencer
LENGTH
KB.MD.SMPL (Keyboard Mode Sample No.)
QUANTIZE
DEL PTRN (Delete Pattern)
SWAP.PTRN (Swap Pattern)
LOAD.PTRN (Load Pattern)
Global parameters
METRONOME (Metronome)
LCD.LIGHT (LCD backlight mode)
PROTECT (Memory protect)
AUDIO IN (Audio in mode)
PTRN CHG (Pattern change mode)
AUDIO IN LVL (Audio In Level)
GLOBAL.CH (Global MIDI Channel)
KB.MIDI.CH (Keyboard MIDI Channel)
LOCAL (MIDI Local Control)
MIDI.ROUT (MIDI Routing)
MIDI CLK (MIDI Clock)
STRT.TRIM (Start Point Auto Trimming)
END TRIM (End Point Auto Trimming)
Global parameters
☞p.30
WRITE BANK
☞p.30
WRITE SAMPLE
☞p.30
WRITE PATTERN
☞p.30
☞p.31
☞p.31
☞p.31
☞p.31
Indication
☞p.32
The operation cannot be executed because the microSAMPLER is in
☞p.32
Cause sampling-standby mode, currently sampling, or the sequencer is run-
☞p.33
ning.
Action Stop the operation that's currently running.
☞p.34
Indication
☞p.34
Cause The data cannot be saved because the battery is low.
☞p.34
Action Connect the AC adapter.
☞p.34
☞p.35
Indication
☞p.35
Cause The data size was too large to be loaded or saved.
Action Check the data size, and reduce it.
☞p.38
Indication
☞p.38
Cause The target sample was not found.
☞p.38
Action Re-specify the sample.
☞p.38
Indication
☞p.39
Cause Memory protect is turned on. (☞p.38)
☞p.39
Action Turn off memory protect.
☞p.39
☞p.39
Indication
☞p.39
When attempting to WRITE SAMPLE or WRITE SEQ, the current bank is
Cause
☞p.39
the ROM bank.
☞p.40
Action Use WRITE BANK to save all of the data.
☞p.40
☞p.40

Error messages

BUSY
BATT LOW
SIZE.OVER
NO.SAMPLE
MEM.PRTCT
ROM.BANK
Appendix
☞p.41
☞p.41
☞p.41
65