3. If you're inputting the oscillator output to the
master effects without sending it to the insert
effects, use the "OSC1 Send1," "OSC1 Send2,"
"OSC2 Send1," and "OSC2 Send 2" settings for
the oscillators to specify the send levels to the
master effects.
These settings are available only if "Bus" is set to L/
R or Off.
If "Bus" is set to IFX1–IFX5, use the "Send1" and
"Send2" parameters following the insert effect
(PROG EDIT: IFX1–IFX5) to specify the send levels
to the master effects.
4. "FXCtrl Bus" sends the output of oscillators 1 and
2 to the FX control bus.
Use this when you want to use a different sound to
control the sound that's being input to an effect. You
can use two FX control buses to freely control the
sound (PG p. 209 "FX Control Bus")
Insert effect
Here's how to adjust settings for insert effect 1.
You can adjust settings for the other insert effects in
the same way.
1. Access the PROG EDIT: IFX1 screen, and press the
button.
The first page of IFX1 is the selection screen for
insert effect 1 ("IFX Select").
Press the button once again, and then use the
buttons to select the effect type for insert effect 1.
You can use the "Copy IFX" command to copy
effect settings from another effect. The "Swap IFX"
command lets you exchange (for example) insert
effects 1 and 5.
If you press the button to enter the page at right,
you'll see the parameters of the selected insert
effect. (step 5)
2. Adjust settings for the insert effect 1 on/off status
and connections.
Use "On/Off" to turn insert effect 1 On.
If this is Off, the result will be the same as if 000: No
Effect is selected; the input sound will be output
without change.
Routing and effect settings Effect settings for a program
3. Turn "Chain" On.
If "Chain" is On, the insert effect will be connected
in series.
Set "Chain To" to IFX2.
If IFX2 is selected, the insert effects will be
connected in series in the order of IFX1 IFX2. The
connection status is shown in the upper line of the
display.
4. Set the "Pan (CC#8)," "Bus," "FXCtrl Bus,"
"Send1," and "Send2" parameters to specify the
pan and routing of the signal following the insert
effect.
If "Chain" is On, the settings that follow the last
insert effect will be used. ("FXCtrl Bus" is an
exception.)
"Pan (CC#8)": Specifies the pan.
"Bus": Specifies the output destination. Normally
you'll set this to L/R.
"Send1," "Send2": Specify the send levels to the
master effects. For this example, set them to 127.
"FXCtrl Bus": The sound that has passed through
the insert effect is then sent to the FX control bus.
This allows you to use a different sound to control
the input to an effect. You can use two FX control
buses, giving you a wide range of possibilities for
controlling the effects. (PG p. 209 "FX Control
Bus")
5. Use the pages located to the right of PROG EDIT:
IFX1 "IFX Select" to edit the parameters of insert
effect 1.
For details on the parameters of each effect, please
refer to PG p. 219 and following.
47