Check After Assembly - Korg Pa588 User Manual

240 Assembling the stand
8. Fix the instrument (D) to the stand (A) from below, by
using the two wing bolts (c). Be sure you insert a washer
(d) between the stand's bottom surface and each of the
wing bolts. Please note the screw hole in the stand's stay
must exactly match the screw hole under the instrument,
so that the screw (c) may enter straight.
Stay
Warning: Please insert the screw (c) straight, or it might
break when forced to fit slanted.
9. Assemble the power cord (F) to the separate power supply
unit (E).
10. Connect the pedal and power cables to the corresponding
instrument connectors. Fix the power supply cable with the
dedicated cable-holder, as shown in the diagram.
11. Place the instrument in the location where it will be played.
Please be sure to place it over a flat floor, to avoid any shak-
ing.
Note: Be careful not to pinch the power cable under the
instrument feet.
12. Tighten and check all the screws.

Check after assembly

[•] Are any parts left over?
If any parts are left over, check the diagrams to see where
they should be used.
[•] Make sure that all screws are tight.
Caution
Caution when transporting the instrument
Remove the instrument from its stand, and transport them sepa-
rately. After transportation, refer to these instructions and re-
assemble the instrument and stand.
Screw loosening
After assembly, the various screws and bolts of the stand may
loosen as time goes by, causing the stand to wobble. If this
occurs, re-tighten the screws.
Disassembly
If you need to packup the instrument, reverse the assembly order
by which the instrument was attached to the stand and the stand
was assembled. After disassembly, save the screws and other
parts so that no parts are lost.