Software Upgrades - JVC KM-H2500 Manual

Loading Memory Registers, Personality, and
Installation Settings
You can load memory registers, personality, and
installation settings that were previously saved to a
USB drive.
Memory registers that were empty when saved will
erase the contents of the same memory register on
your switcher when loaded from a USB drive.
To load from a USB drive:
2
3
1. Insert a USB drive containing memory register,
personality, and installation sets into the USB
port.
2. Press MENU.
3. Press the LOAD Wipe Pattern button.
4. Use the left knob to select the set you wish to
load from.
5. Load memory registers, personality settings,
installation settings, or all settings as follows:
• Press the All knob to load memory registers,
personality settings, and installation settings
from the selected set.
• Press the Mems knob to load memory
registers from the selected set.
• Press NEXT and then the Pers knob to load
personality settings from the selected set.
• Press the Inst knob to load installation
settings to the selected set.
6. Press the Confrm knob to perform the save.
Press the Cancel knob to cancel the save.
Note:
• Turn the middle knob when browsing sets to
display the full text of long set names
• The * symbol next to an item indicates that there is
a previously saved version of that item in the
selected set.
For More Information on...

Software Upgrades

Software upgrades stored on a USB drive can be
uploaded to the switcher.
4,5
Do not turn the switcher power off during the
upgrade.
To upgrade the switcher software:
3
4 5
1. Copy a software upgrade file onto a USB drive.
2. Insert the USB drive with the software upgrade
file into the USB port.
3. Press MENU.
4. Press the RESET Wipe Pattern button.
5. Press NEXT until Run Software Upgrade From
USB is displayed.
6. Press the left knob to display the Upgrade menu.
7. Select an upgrade file to use as follows:
• Use the left knob to browse the USB drive file
system. Turning the knob cycles through all
the files and directory names at the current
level in the file system.
• Navigate to sub-directories by selecting a
sub-directory name and then pressing the left
knob. Sub-directories are displayed as
<directory-name>
• Return to a parent directory by selecting <..>.
• Use the left knob to select the upgrade file you
wish to use.
8. Press the left knob to load the upgrade file.
9. Press the Confrm knob to initiate an upgrade.
Press the Cancel knob if you do not wish to
perform an upgrade.
The menu displays a message indicating the software
upgrade is in progress. The Upgrade LED on the rear
of the switcher is lit, indicating an upgrade is in
progress.
Note:
• Wait 5 seconds after inserting a USB drive into the
USB port before using it.
• Turn the middle knob when browsing the file
system to display the full text of long directory lists
and filenames.
• Upgrades can take several minutes to complete.
• If CRITICAL UPGRADE is displayed, the switcher
is performing an upgrade that includes low-level
software components. This does not indicate a
problem with your switcher.
6
39