Jet JMS-10SCMS Benchtop Series Operating Instructions And Parts Manual page 16

6. Repeat steps 1–4 if necessary until the blade is
45° to the table, then tighten the lock nut (D,
Fig. 12) to secure the stop bolt (C, Fig. 12).
33.9° Left & Right Bevel Adjustment
1. Set the miter angle to zero degree. Fully extend
both sliding fences.
2. Loosen the bevel lock handle (A, Fig. 8).
3. Tilt the cutting arm to the 33.9° left bevel
position and engage the positive stop by
pushing the bevel detent pin (E, Fig. 12) in.
4. Using a combination square, check to see if the
blade is 33.9° to the table.
5. To adjust, turn the setscrew (A, Fig. 14) in or
out with a 3mm hex wrench until the blade is
33.9° to the table.
6. Repeat steps for the right bevel 33.9º bevel
adjustment, making adjustments to setscrew B,
Fig. 15.
Miter Angle
The sliding compound miter saw scale can be
easily read, showing miter angles from 0° to 45° to
the left, and 0° to 60° to the right. The miter saw
table has ten of the most common angle settings
with positive stops at 0°, 15°, 22.5°, 31.6°, and 45°
left and right and 60° right. These positive stops
position the blade at the desired angle quickly and
accurately. Follow the process below for quickest
and most accurate adjustments.
Referring to Figure 16:
1. Lift up on the quick-cam miter table lock (A) to
unlock the table.
2. Lift up on the positive stop locking lever (C) and
move the turntable with handle (B) to align the
indicator (D) to
measurement.
3. Lock the table into position by pressing down
on the quick-cam miter table lock (A).
Miter Scale Indicator Adjustment
4. Move the table to the 0° positive stop.
5. Loosen the screw (E) that holds the indicator
with a screwdriver.
6. Adjust the indicator (D) to the 0° mark and
retighten screw.
the desired degree
Figure 14
Figure 15
Figure 16
16