Care Of Your Machine; Replacing The Upper Knife; Cleaning Upper Knife Area - Janome 1110DX Instruction Book

3
1
0.8 ~ 1.5 mm (3/64˝)
4
2
3

CARE OF YOUR MACHINE

Replacing the Upper Knife

To remove:
1. Turn off the power switch and unplug the machine.
4
2. Open the looper cover and side cover.
2
3. Deactivate the upper knife.
4. Remove the hexagonal bolt, and remove the
To attach:
1. Insert new upper knife into the groove of knife
1
2. Turn the upper knife holder to cutting position.
3. Turn the handwheel toward you until the upper
4. Close the looper cover and side cover.

Cleaning Upper Knife Area

1. Turn off the power switch and unplug the machine.
2. Open the looper cover.
* You may use a vacuum cleaner to clean the upper
* The lower knife will last over one year in normal
86
upper knife.
1 Upper knife
2 Hexagonal bolt
3 Stopper pin
4 Lower knife
holder and stopper pin, then tighten the
hexagonal bolt slightly.
knife comes to its lowest position.
Loosen the hexagonal bolt, and adjust the
position of the upper knife so that the edge of the
upper knife overlaps 0.8 to 1.5 mm (3/64´´) from
the edge of lower knife as illustrated.
Then tighten the hexagonal bolt firmly.
Remove the waste pieces to the front with a lint
brush.
knife area or feed dog.
use. However, if you run over a pin or a hard
object, it may be required to replace both upper
and lower knives at the same time.