Threading The Looper - Janome COVER PRO 1000CP Instruction Book

8
7
6
q
1
(B)
2
w
2
3
4
5
(A)

Threading the looper

1
Thread the looper in the following steps:
1 Draw the thread through the right side thread
guide bar from back to front as shown (A).
NOTE:
If the thread is coming out from the thread guide notch,
pass the thread through the thread guide hole again as
shown (B).
q Thread guide bar
2. Pass the thread through the holes on the right side
of the thread guide plate as illustrated.
w Thread guide plate
13