Raising Or Lowering The Presser Foot; Removing The Presser Foot; Attaching The Presser Foot; Adjustment Of Foot Pressure - Janome COVER PRO 1000CP Instruction Book

w
w
e
q
w
r
10 mm
q
q
e
e
q
w

Raising or Lowering the Presser Foot

By raising or lowering the presser foot lifter, the presser
foot goes up or down.
* While in operation, keep the presser foot lowered
except when threading the machine or test
running without threads.
NOTE:
Thread tension will be released when the presser foot
lifter is raised.
q Presser foot
w Presser foot lifter

Removing the Presser Foot

1 Turn off the power switch and unplug the
machine.
2 Turn the handwheel toward you to raise the needle.
Raise the presser foot.
3 Press the lever located on the back of the foot
holder. The presser foot will drop off.
q Handwheel
w Lever
e Foot holder

Attaching the Presser Foot

1 Turn off the power switch and unplug the
machine.
2 Place the presser foot so that the pin on the foot
lies just under the groove of the foot holder.
3 Lower the foot holder to lock the foot into place.
4 Raise the presser foot lifter to check that the
presser foot is secure.
q Foot holder
w Groove
e Pin

Adjustment of Foot Pressure

It is not necessary to adjust the presser foot's pressure
for normal sewing.
When you sew heavy or lightweight fabrics, turn the
adjusting screw:
–– clockwise for heavyweight fabric.
–– counterclockwise for Iight weight fabric.
* For regular sewing, set the adjusting screw so
the head protrudes 10 mm from the top of the
machine.
q To decrease
w To increase
e Adjusting screw
r Top of the machine
6