Rinnai RHFE-431FA Owner's Operation And Installation Manual page 6

12. YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN THEY ARE IN THE SAME
ROOM WITH THE HEATER.
13. LPG containers must not be installed indoors.
14. Do not use this room heater if any part has been under water. Immediately call a qualified service
technician to inspect the room heater and to replace any part of the control system and any gas
control which has been under water.
15. Adequate clearances for accessibility for purposes of servicing and proper operation should be
provided.
16. Adequate clearances around air openings should be provided.
17. Do not install in areas where curtains, drapes, clothing, or other moving flammables are within 12
inches of this unit.
18. Periodic examination of the venting system is required.
19. The flow of combustion and ventilation air should not be obstructed.
20. A manufactured home (USA only) or mobile home OEM installation must conform with the
Manufactured Home Construction and Safety Standard, Title 24CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home Installations, ANSI Z225.1 or
Standard for Gas Equipped Recreational Vehicles and Mobile Housing, CSA Z240.4.
21. "This appliance must be installed in accordance with the current standard CSA Z240.4 GAS
EQUIPPED RECREATIONAL VEHICLES AND MOBILE HOUSING. Cet appareil doit ette installe
conformement aux, exigences de la norme Z240.4 en vigeuer de l'ACNOR, Installations de gaz dans
les constructions mobiles et vehicules recreatifs."
22. If a blockage occurs at vent terminal due to snow, leaves or other type of obstruction the unit will
stop working. The unit will not function until blockage has been removed then if unit fails to operate,
contact a qualified service agency.
23. For a manufactured home (USA only) or mobile home OEM or residential or light commercial installation,this
unit has been designed and certified to be converted from natural gas to propane or vice-versa. When
provisions are being made to convert this unit, a certified conversion kit must be used. You must also
readjust manifold gas pressure to specifications indicated in the conversion manual. If in doubt, contact
Rinnai America for assistance.
– 4 –