Radio Shack 60-4458 User Manual

James Bond Aston Martin DBS
1:12 Scale RC Car
Note: Actual product may vary from the images found in this document.
what's included
James Bond Aston Martin DBS
Transmitter Antenna User's guide
Vehicle Antenna Tube
Please read this user's guide before
installing, setting up and using your new car
www.radioshack.com
Thank you for purchasing your James
Bond Aston Martin DBS 1:12 Scale RC
60-4458
Car from RadioShack. Your vehicle comes
in two frequencies (27MHz and 49MHz),
so you and your friends can drive your
car.
Transmitter
• Do not use your vehicle near devices with
transmitters using the same frequency (27
or 49 MHz).
• If someone uses a CB nearby, it might
interfere with the control of your vehicle. If
this happens, move the vehicle away from
the CB.
installing your batteries
In your transmitter
Your transmitter requires one 9V alkaline
battery (not supplied). Replace the battery
when your transmitter's control range
decreases.
1. Open the battery cover and insert the
battery as marked (+ and -).
2. Replace the cover.
In your vehicle
Your vehicle requires one 9.6V rechargeable
battery pack (not supplied).
1. Set ON/OFF on the vehicle under the body
on the driver's side to OFF.
2. Use a coin to turn the battery compartment
latch to OPEN.
3. Slide the battery compartment cover in the
direction of the arrow and lift to open it.
4. Attach the vehicle's connector to battery
pack. Do not force them; they fit together
only one way.
5. Place the battery pack in the battery
compartment. The battery pack's
connector must be on the same side as
the car's matching connector.
6. Close the lid and snap it shut.

safety information

• Never play with the vehicle in the street.
• Be careful when you use the vehicle to
avoid high-impact collisions with people
and objects.
• If your vehicle does not respond, drives
slowly, or the range reduces, recharge the
batteries in the vehicle.