Advertisement
TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
Cause
The car ignition is not on.
No power
The fuse is blown
Presence of CD disc inside
Disc cannot
the player
be loaded or
Inserting the disc in upside
ejected
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum
No sound
Wiring is not properly
connected
The installation angle
Sound skips
is more than 30 degrees
The disc is extremely
dirty or defective
The radio does
The antenna cable is not
not work
connected
the signals are too weak
Solution
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
Replace the fuse
Remove the disc in the player
then put a new upward
Insert the compact disc with
the label facing upward
Clean the disc or try to play a
new one
Cool off until the ambient
temperature returns to normal
Leave the player off for an
hour or so, then try again
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle
to less than 30 degrees
Clean the compact disc/try to
play a new one
Insert the antenna cable firmly
6. CD
( CD PLAY, PAUSE) BUTTON
At tuner mode, press
button to switch to CD mode. At CD mode,
press it to pause the CD program and press it again to resume CD
playback.
7. EJECT BUTTON
Press it to eject the disc from the slot.
8.9.10. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTON
Press SEL button to change the mode in sequence as follow:
VOL
BAS
TRE
a. The volume level can be adjusted at any time by pressing the audio level
+ or - button as select mode has been initially defaulted at volume mode.
b. The volume level is also obtained by stepping through the SEL button until
the function VOL is displayed and then press + or - button to adjust the
sound level.
c. Press and hold the + or - button to adjust the sound level.
BASS CONTROL
a. Press the SEL button to select the bass mode until BAS appears on the display.
b. Press + or - to adjust the bass effect.
TREBLE CONTROL
a. Press the SEL button to select the treble mode until TRE appears on the display.
b. Press + or - to adjust the treble effect.
BALANCE CONTROL
a. Press the SEL button to select the balance mode until BAL appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
left or right speaker.
FADER CONTROL
a. Press the SEL button to select the fader mode until FAD appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
front or rear speaker.
11. EQ BUTTON
Press it to apply these function. Press it continually to switch between 3
preset equalizer curves: POP, CLAS, ROCK. The sound quality will be changed.
Press it again to cancel these function.
12. MUTE BUTTON
Press it to eliminate the sound temporarily, and press again to resume
normal play state.
BAL
FAD
Advertisement
