Installation; Siting; Appliances Equipped With Casters; Appliances Equipped With Legs - Sunfire SX SERIES Installation And Operation Manual

INSTALLATION

This product has been certified as commercial cooking
equipment and must be installed by professional personal
as specified. THIS APPLIANCE IS NOT RECOMMENDED FOR
RESIDENTIAL INSTALLATION.
We suggest installation, maintenance and repairs should be
preformed by your local Garland authorized service agency.

Siting

The floor on which the appliance is to be sited must be
capable of adequately supporting the weight of the
appliance and any ancillary equipment.
Units with ovens must be fitted with legs if installed on a
combustible floor.
Adequate clearance must be provided for servicing and
proper operation.

Appliances Equipped with Casters

1. The installation shall be made with a connector that
complies with the Standard for Connectors for Moveable
Gas Appliances, ANSI Z21.69/CSA 6.16, Addenda Z21.69B-
2006/CSA 6.16B-2006 (or latest edition), and a quick-
disconnect device that complies with the Standard for
Quick Disconnects for Use with Gas Fuel, ANSI Z21.41/
CSA 6.9, Addenda Z21.41A-2005/CSA 6.16A-2005 (or
latest edition).
2. The front casters on the appliance are equipped with
brakes to limit the movement of the appliance without
placing any strain on the connector or quick disconnect
device or its associated piping.
3. Please be aware; required restraint is attached to a
bracket, (which is located on the rear of the caster closest
to the gas connection), and if disconnection of the
restraint is necessary, be sure to reconnect the device
after the appliance has been returned to its original
position.
Page 6

Appliances Equipped with legs

1. Raise the front of the appliance and block. Do not lay the
appliance on its back.
2. Position a leg insert in leg retainer opening and tap
upward until the insert seats at the collar flange.
3. Repeat leg insert installation for the other three legs and
adjust all four legs to the same height.
4. Legs can be further adjusted to level the appliance and to
compensate for uneven flooring.

Installing Shelf to Backguard

Note: Shelf may be installed before or after installing the
backguard to the range.
1. Loosen 4 bolts on the front of the backguard
approximately 1/4" (6mm).
2. Align the 4 holes on the back of the shelf with the 4 bolts
on the backguard.
3. Slide the shelf downward until the 4 bolts are engaged in
the slotted portion of the keyhole.
4. Tighten the 4 bolts to secure shelf.
5 On 60" units only, install a sheet metal screw though the
hole in the underside of the shelf into the backguard and
tighten.
MOUNTING
BOLTS
BACKGUARD
SHELF
SHEETMETAL
SCREW
Part # 4515146 (02/29/08)