Table of Contents
Advertisement
INTRODUCTION
Periodic inspections by your dealer or a qualified service
agency are recommended .
We suggest installation, maintenance and repairs should be
performed by your local authorized service agency listed
in your information manual pamphlet, or you may call the
factory at 1-800-2-211 .
INSTALLATION
Clearances
The clearance from combustibles on the AP1 & AP is six (6")
inches, (152mm) on the right and rear side and zero (0") on
the left . It is recommended that there be six (6") (152 mm) of
clearance on the right side for fuse panel access .
Location
Proper placement of the oven will ensure operator and
satisfactory performance . Adequate clearance must be
provided for servicing, ventilation (if applicable), and
proper operation . The oven must be kept free and clear of
combustible material .
WARNING Control components may experience reduced
life if exposed to high temperatures . We recommend not
exposing control areas to temperatures above 10 degrees
Fahrenheit for a continuous period of time . For this reason,
care must be taken on installation to allow air flow around
units, especially when placed near other heat producing
sources . We recommend 6" (152 mm) spacing to the control
side of oven from other heat producing sources .
Installation for Ovens Equipped with Legs
The AP1 counter unit is shipped with four () legs . This unit
is stackable up to three (3) units . The AP1 is considered the
base appliance and the APA is the stacking appliance .
WARNING: The base of counter appliance must be installed
with minimum " legs . The base appliance needs air
flow from the bottom for proper operation and is a NSF
requirement .
CAUTION: DO NOT LAY UNIT ON SIDES OR TOP .
Page 6
Rating Plate
When corresponding with the factory or your local
authorized factory service center regarding service problems
or replacement parts, be sure to refer to the particular unit
by the correct model number (including the prefix and suffix
letters and numbers) and the warranty serial number . The
rating plate affixed to the unit contains this information .
Installation for Ovens Equipped with Casters
It is recommended that in the use of casters a strain relief be
installed on the appliance . This will prevent any excess strain
on the terminal connection if the appliance is rolled out for
cleaning or servicing .
The front casters of the unit are equipped with brakes to
limit the movement of the oven without depending on the
connector and any quick disconnect device or its associated
wiring to limit the appliance movement .
Please be aware, there is a restraint on the unit and if
disconnection of the restraint is necessary, be sure to
reconnect the restraint after the oven has been returned to
its originally installed position .
Stacking Instructions
To Stack APA on top of an AP1 Unit
WARNING The maximum number of units to be stacked is
two additional units on top of the single base unit .
WARNING DISCONNECT ALL WIRING AND PLUGS FROM
ELECTRICAL SOURCE .
Items required to complete stacking procedure:
1 – AP1 oven with top and legs .
1 or 2 APA ovens without top and legs .
Phillips screwdriver
7/16" open end wrench .
Part # 1382636 Rev 5 (01/25/08)
Hide quick links:
Advertisement
Table of Contents
