SERVICE AND ADJUSTMENTS
TO REPLACE GROUND DRIVE BELT
(See Fig. 21 and 22)
•
Remove belt guard (See "TO REMOVE BELT GUARD"
in this section of this manual).
•
Remove old belt by slipping off engine pulley first then
remove from transmission pulley.
•
Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
•
Check belt adjustment as described below.
•
Replace belt guard.
•
Reposition wheel and replace clevis pin and hairpin
clip.
ENGINE
PULLEY
IDLER
PULLEY
GROUND DRIVE BELT ADJUSTMENT
(See Fig. 22)
For proper belt tension, the extension spring should have
about 5/8" stretch when tine control is in "EN GAGED" posi-
tion. This tension can be attained as follows:
•
•
•
TRANS MIS SION PULLEY
Fig. 22
15
Loosen cable clip screw securing the drive control
cable.
Slide cable forward for less tension and rearward for
more tension until about 5/8 inch stretch is obtained
while the tine control is engaged.
Tighten cable clip screw securely.
LESS
TEN SION
EXTENSION
SPRING
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
MORE
5/8"
TEN SION