Introduction
The following explains how to setup PC operation with RUSKA LEMCal software and a
single LEM.
Interconnect
The standard interface cable for the LEM is a DB9 F/F cable. The green indicator light
should come on when the power plug is connected.
Software Installation
1. Insert CD into drive.
The AutoRun function should begin the installation.
2. If the AutoRun function does not begin then Select Start and Select Run.
Type D:\Setup (where D is your CDROM directory)
3. Double Click on the new LemCal icon in the RUSKA Instrument Program group.
At this point, the System should display data. If not, or if customization is desired then
continue with the section below.
Software Setup
Help Menus
The LEM software contains extensive help menus that provide detailed information about
each function.
Serial Port Setup
From the menu select Setup | Communication.
Chapter 2
Getting Started
2-1