Ice Maker And Storage Bin; To Dispense Water; The Ice Dispenser; The Dispenser Light - Whirlpool WRS342FIAM00 User Manual

To Dispense Water:
1. Press ICE/WATER until "water" is selected, as shown
on the display screen.
2. Press a sturdy glass against the dispenser lever. Hold
the glass close to the water dispenser spout to ensure
that the water dispenses into the glass.
_ A
A. Water dispenser spout
3. Remove the glass to stop dispensing.
IMPORTANT: The small tray at the bottom of the dispenser is designed
to catch small spills and allow for easy cleaning. There is no drain in the
tray. To empty and clean the tray, push down on the back of the
removable tray lid and pull it out.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when the
dispenser lever is pressed. To turn off the ice maker, see "Ice Maker
and Storage Bin."
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer by pressing the ICE/
WATER button.
The display screen indicates which type of ice is selected.
CRUSHED CUBED
For crushed ice, cubes are crushed before being dispensed. This may
cause a slight delay when dispensing crushed ice. Noise from the ice
crusher is normal, and pieces of ice may vary in size. When changing
from crushed to cubed, a few ounces of crushed ice will be dispensed
along with the first cubes.
To Dispense Ice'.
1. Make sure the desired type of ice is selected.
2.
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
Press a sturdy glass against the dispenser lever. Hold the glass
close to the ice guide to ensure that the ice dispenses into the
glass.
A. Ice guide
3.
IMPORTANT: You do not need to apply a lot of pressure to the lever
in order to activate the ice dispenser. Pressing hard will not make
the ice dispense faster or in greater quantities.
Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the lever. The dispenser may continue to
make noise for a few seconds after dispensing.
The Dispenser Light
When you use the dispenser, the light will automatically turn on.
• If you want the light to be on continuously, press
LIGHT. The display screen indicates when the light
is set to stay on.
• Press LIGHT again to turn the dispenser light off.
The dispenser lights are LEDs that cannot be changed.
If it appears that your dispenser lights are not working, see "Problem
Solver" for more information.
The Dispenser Lock
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the refrigerator, to
the ice maker, or to the dispenser light. It simply deactivates the
controls and dispenser lever. To turn off the ice maker, see "Ice Maker
and Storage Bin."
• Press and hold LOCK for 3 seconds to lock the dispenser.
• Press and hold LOCK a second time to unlock the dispenser.
The display screen indicates when the dispenser is locked.
IIIIoeMaker and Storag÷ Bin
• Do not store anything on top of or in the ice maker or storage bin.
• Allow 24 hours to produce the first batch of ice. Discard the first
three batches of ice produced.
• The quality of your ice will be only as good as the quality of the
water supplied to your ice maker. Avoid connecting the ice maker to
a softened water supply. Water softener chemicals (such as salt)
can damage parts of the ice maker and lead to poor quality ice. If a
softened water supply cannot be avoided, make sure the water
softener is operating properly and is well maintained.
• Do not use anything sharp to break up the ice in the storage bin.
This can cause damage to the ice container and the dispenser
mechanism.