Table of Contents
Advertisement
STEP 3: Attach Throttle Control
Lever
1. One end of the Throttle Control Cable
(H, Figure 2-3) is attached to the engine.
Gently unwind the cable from its shipping
position and position the Throttle Control
Lever (I) on the outside of the right han-
dlebar, next to the throttle control decal.
2. Securethe Throttle Control Leverto
the handlebar with a 1t4-20 x 2 hex hd.
screw (J, Figure 2-3) and 1t4-20 hex
Iocknut (K).
3. Use a cable tie (L, Figure2-3) to
secure the throttle cable (H) to the han-
dlebar at the location shown.
STEP 4: Add Motor Oil
1. Theengine is shipped without motor
oil which MUST BE ADDEDbefore the
engine is started.
2. Seethe engine manual for filling
instructions and for the correct oil speci-
fications. Enginemust be level when
checking oil level. In ambient tempera-
tures above 40oF, use a high-quality, SAE
30 weight detergent oil classified for Ser-
vice SF, SGor SH. Use no special addi-
tives. Do not mix oil with fuel.
//
/
/
/
/
/
/
f
Figure 2-2."Handlebar installation (electric start model shown).
STEP 5: Check Trimmer Head
Hardware
Check that the two bolts (M, Figure 2-4)
on the trimmer head are tightened
securely. Thetrimmer head can be
rotated to make access to the hardware
easier.
IMPORTANT:The trimmer head hardware
is designedto be permanently installed
and is not removable. Do not attempt to
replace it with non-factory specified hard-
ware.
NOTE:The two holes (one is covered with
a plastic plug) on the top, front end of the
mower deck are access holes that allow
certain parts to be serviced.
I
I
Figure2-3."Attach throttlelever to right-side
handlebar.
M
Figure2-4: Checktrimmer headhard=
warefortightness.
Advertisement
Table of Contents
