Setting Up The Player; Using The Setup Navigator - Pioneer DV-S88A Operating Instructions Manual

Setting Up the
Player

Using the Setup Navigator

The Setup Navigator has been designed to simplify the
process of getting the DVD player ready to perform.
Designed as a series of on-screen multiple-choice
questions, the Setup Navigator automatically sets the
audio, video, and language settings according to how the
questions are answered. Once this procedure is
complete, it will be possible to begin using the DVD
player to enjoy DVDs.
The procedure on this page describes the operations
necessary to function within the Setup Navigator
screens. A detailed description of the contents of each
question that appears on the screen can be found on the
following pages.
When setting up for the first time
Some DVDs start playing automatically when loaded in
the player. Because the Setup Navigator cannot be used
if a disc is playing, it is recommended to set up the player
using the Setup Navigator before loading a DVD for the
first time. If a DVD has been loaded, be sure to press
STOP 7 before proceeding.
Procedures in this section use the DV-S88A.
Differences in procedures of other models are clearly
marked by white numbered steps.
1
2
3
1(1)
20
En
OPEN /
CLOSE
DISPLAY AUDIO SUBTITLE ANGLE
SET UP TOP MENU
MENU
4
ENTER
FUNCTION VIDEO
MEMORY ADJUST DIMMER JOG MODE
F.MEM V.ADJ FL JOG
STOP PLAY PAUSE
7 3 8
PREVIOUS NEXT REV FWD
4 ¢ 1 ¡
RETURN STEP / SLOW SEARCH MODE
e E
CLEAR
1 2 3 C
4 5 6 + 10
7 8 9 0
RANDOM REPEAT PROGRAM
A-B
LAST CONDITION
MEMORY MEMORY
Î
DVD PLAYER
AUDIO / VIDEO
1
Press STANDBY/ON on the front panel
( on the remote control). (DV-S88A)
1
Press POWER on the front panel. (DV-
S838A)
2
Press SETUP.
When SETUP is pressed for the first time, the
following screen appears. Though the Setup
Navigator may be used more than once, this screen
only appears the first time SETUP is pressed.
Audio1 Audio2
Setup Navigator
Setup Navigator
Setup using the Setup Navigator
Move
3
Move the cursor control joystick up or
down to make a selection.
• If you are going to use the Setup Navigator, it is
not necessary to change the setting on the first
screen. Please proceed to the next step.
• If you do not want to set up the player using
the Setup Navigator, use the cursor control
joystic down to select [Auto Start Off] at this
time.
The Setup Navigator function may still be used at
a later time in manual Setup screen menu
operation (page 30).
4
Press ENTER.
The selection is entered and the next Setup
Navigator screen appears.
Use steps 3 and 4 as a basis for entering selections on all
of the Setup Navigator screens described on the
following pages.
To change the answer to a prior question
Move the cursor control joystick left to return to
previous screens. Please note, however, that you cannot
go forward by moving the cursor control joystick right,
so it will be necessary to answer all the questions that
occur after the screen that was returned to.
To exit the Setup Navigator
Press SETUP while on any of the screens to exit the
Setup Navigator. Please note that if the Setup Navigator
is exited before all the questions are answered, no
settings are changed.
To return to the Setup screen
Press RETURN . The Setup Navigator is exited and the
Setup screen General menu screen appears. Please note
that no settings are changed if RETURN
before the Setup Navigator is finished.
Video Language General
Start
Auto Start Off
ENTER Select SETUP Exit
is pressed