Table of Contents
Advertisement
Connecting to Optional Equipment
Connecting to an amplifier equipped with two
channel analog stereo or Dolby Surround
Connect the Left and Right AUDIO OUT jacks on the
DVD Player to the audio left and right in jacks on your
amplifier, receiver or stereo system, using the supplied
audio cables (A).
Connecting to an amplifier equipped with two
channel digital stereo (PCM) or to an Audio/
Video receiver equipped with a multi-channel
decoder (Dolby DigitaF M, MPEG 2 or DTS)
Connect one of the DVD Player's DIGITAL AUDIO
OUT jacks (OPTICAL O or COAXIAL X) to the cor-
responding in jack on your amplifier. Use an option-
al digital (optical O or coaxial X) audio cable.
You will need to activate the player's digital output.
(See "Digital Audio Output" on page 14).
e_
Digital
Multi-channel
sound
A digital multi-channel
connection provides the best
sound quality. For this you need a multi-channel
Audio/Video
receiver that supports one or more of the
audio formats supported by your DVD Player (MPEG 2,
Dolby Digital and DTS). Check the receiver manual and
the Iogos on the front of the receiver.
Rear of DVD player
II
_]_
COT COMPONENT
VIDEO
OUT
y
COIII_BIT
,
® ®
"_'
PIt
I_
_
LS.VIDE
O
PB
i
Ol
?
0
/
Amplifier (Receiver)
A
X
i
This player does not perform internal (2 channel)
decoding of a DTS sound track. To enjoy DTS
multi channel surround, you must connect this player to
a DTS compatible receiver via one of this player's
digital audio outputs.
- If the audio format of the digital output does not match
the capabilities of your receiver, the receiver will
produce a strong, distorted sound or no sound at all.
- Six Channel Digital Surround Sound can only be
obtained if your receiver is equipped with a Digital
Multi-channel
surround sound decoder.
- To confirm the audio format of the current DVD
selection display, press AUDIO.
- Repeated pressing of the AUDIO button may allow
you to select between various audio formats available
on the disc.
Advertisement
Table of Contents
