Assembly; Unfolding The Handle - Toro Recycler 20010 Operator's Manual

Assem y
Note: Determine the left and right sides of the lawn
mower by standing in the operating position.
Unfolding the Handle
Models 20010, 20020, and 20028
POTENTIAL HAZARD
+ Folding or unfolding the handle improperly can
pinch, stretch, or damage one or more of the
cables.
WHAT CAN HAPPEN
* Any pinched, stretched, or damaged cable may
cause an operational failure that results in an
unsafe operating condition.
HOW TO AVOID THE HAZARD
* Do not pinch, stretch, or damage the cables.
* Handle the cables with care when folding or
unfolding the handle.
* Do not use the lawn mower if one or more of
the cables are pinched, stretched, or damaged.
Contact your Authorized Service Dealer.
1.
Loosen the handle knobs and lift the top handle half in
an arc until the handle halves are in line and nest
together (Fig. 2).
1679
Knob
Figure 2
2. Top handle half
2. Tighten the knobs securely.
3. Rotate the handle toward the rear of the mower until it
snaps into the handle brackets (Fig. 2).
Model 20021
POTENTIAL HAZARD
* Folding or unfolding the handle improperly can
pinch, stretch, or damage one or more of the
cables.
WHAT CAN HAPPEN
* Any pinched, stretched, or damaged cable may
cause an operational failure that results in an
unsafe operating condition.
HOW TO AVOID THE HAZARD
* Do not pinch, stretch, or damage the cables.
* Handle the cables with care when folding or
unfolding the handle.
* Do not use the lawn mower if one or more of
the cables are pinched, stretched, or damaged.
Contact your Authorized Service Dealer.
1.
2.
3.
Loosen the handle knobs and lift the top handle half in
an arc until the handle halves are in line and nest
together.
Lightly tighten one of the handle knobs.
Insert the left end of the lower handle and the end of
the cable guide onto the pin on the left handle
mounting bracket (Fig. 3).
1.
1
\
Figure 3
Handle mounting bracket 2. Cable guide
m-4357
4. Squeeze the handle together, installing the right end of
the lower handle onto the pin on the right handle
mounting bracket (Fig. 3).
IMPORTANT: Make sure the cables are routed on the
inside of the handles and the starter rope is to the
outside (Fig. 4).
6